WATTSTUNDE® DXM2/S roof feedthrough / cable entry for 2 cables including cable management and plug support

WATTSTUNDE ABS cable and roof feedthrough DXM2/S with MC4 bracket

For sticking on the vehicle roof with PG screw connection and support for MC4 connector

The ABS roof duct is simply glued to the vehicle roof using our Betalink K1 or Sikaflex 252i adhesive. The PG cable glands can accommodate a maximum cable diameter of 12 mm and a minimum cable diameter of 4 mm. The pre-drilled holes allow you to screw the cable duct to suitable surfaces, e.g., for a garden shed or other off-grid applications.

WATTHOUR roof duct DXM2/S:

• Two cable entries with cable management and plug-in system holder
• Aerodynamic shape prevents driving noise
• Black and inconspicuous
• Can be glued or screwed.
• UV and weather resistant
• Holds cables with a diameter of 4mm - 12mm tightly and fixes the plug connection
• Dimensions approx. L 18.2 x W 9.7 x H 4 cm

WATTSTUNDE® roof penetrations promise the highest level of safety. They are both UV- and weather-resistant and completely waterproof (IP68 standard). The PG safety screw connections ensure a flush and seamless sheathing of the cables, preventing the ingress of dirt and water.
The M version of the cable and roof penetration also features a special bracket for the connectors to ensure clean cable management . The MC4 connectors are firmly attached to the roof penetration and cannot move freely, even in wind and weather. Protect not only your cables but also the connector system to prevent them from becoming exposed to water or dirt, potentially becoming a weak point in your system.
The roof ducts complete your motorhome fastening system consisting of holding spoilers , fastening corners and connectors and enable a solid attachment of your solar island system to the vehicle roof and a safe introduction of the cables into the living area.